How do I run at 32MHz?

Forums Forums General How do I run at 32MHz?


This topic contains 1 reply, has 2 voices, and was last updated by  Mike Berry 12 months ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
  • #2270


    I guess changing the xtal is the obvious way, but is there a programmatical way to start at 16 then kick up to 32? Should this be a FAQ?


    Mike Berry

    Hi Bob-

    When you say “programmatical”, do you mean through commands in your sketch, or just a way to run at 32MHz without getting out your soldering iron? We don’t support switching between 16MHz and 32MHz via sketch commands, but we do support 32MHz via an FPGA image upload, and you can find information on doing that by watching this video.

    Hope that helps!


Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.